12mg of Retatrutide from a 60mg vial in 3.5mL: how many units?

Answer

Draw 70 units on a U-100 insulin syringe. A 60 mg Retatrutide vial reconstituted with 3.5 mL of bacteriostatic water is 17.14 mg/mL, so 12 mg is 0.7 mL. That vial holds about 5 doses at this strength.

This page also answers

  • How many units is 12mg of reta?
  • 12mg reta on a U-100 syringe
  • What do I draw for 12mg if I used 3.5ml?
  • 12 mg reta in units

Your draw

Vial 60 mg
Bacteriostatic water 3.5 mL
Concentration 17.14 mg/mL
Dose 12 mg
Volume to draw 0.7 mL
U-100 syringe 70 units
U-40 syringe 28 units
Doses per vial 5

Dose chart: 60 mg vial in 3.5 mL

DoseVolumeU-100 unitsU-40 unitsDoses per vial
0.25 mg 0.015 mL 1.5 0.6 240
0.5 mg 0.029 mL 2.9 1.2 120
0.75 mg 0.044 mL 4.4 1.8 80
1 mg 0.058 mL 5.8 2.3 60
1.5 mg 0.088 mL 8.8 3.5 40
2 mg 0.117 mL 11.7 4.7 30
2.5 mg 0.146 mL 14.6 5.8 24
3 mg 0.175 mL 17.5 7 20
3.5 mg 0.204 mL 20.4 8.2 17
4 mg 0.233 mL 23.3 9.3 15
5 mg 0.292 mL 29.2 11.7 12
6 mg 0.35 mL 35 14 10
7 mg 0.408 mL 40.8 16.3 8
8 mg 0.467 mL 46.7 18.7 7
9 mg 0.525 mL 52.5 21 6
10 mg 0.583 mL 58.3 23.3 6
11 mg 0.642 mL 64.2 25.7 5
12 mg 0.7 mL 70 28 5

Doses that would need more than a full 1 mL syringe are omitted. Use less bacteriostatic water for those.

Common questions

What if I used a different amount of water?
Then the unit number changes. Units depend on concentration, not just dose. Run your actual vial size and water volume through the reconstitution calculator rather than copying a number from a chart that assumes 3.5 mL.
Is that on a U-100 or U-40 syringe?
70 units is the U-100 reading, the standard insulin syringe at 100 units to 1 mL. On a U-40 syringe the same 0.7 mL reads 28 units.
How many 12 mg doses will this vial give?
About 5 doses from a 60 mg vial. Reconstitution volume doesn't change that. It only changes how many units you draw each time.
How long is it good for after mixing?
Refrigerate reconstituted peptide at 36–46°F (2–8°C). Most references give 28–60 days once mixed, depending on the preservative in the bacteriostatic water. Do not freeze it, and inspect for cloudiness or particles before every draw.

Run your own numbers

These figures assume the vial and water volumes named above. Change either one and the units change with it.