10mg Retatrutide with 3.5mL bacteriostatic water: dose chart
Answer
10 mg of Retatrutide in 3.5 mL of bacteriostatic water gives 2.86 mg/mL. A 2.5 mg dose is 0.875 mL, or 87.5 units on a U-100 syringe, about 4 doses per vial.
This page also answers
- How many units is 10mg of reta in 3.5mL?
- 10mg reta 3.5ml mixing chart
- What concentration is 10mg in 3.5mL?
- I put 3.5mL in my 10mg vial, now what?
Dose chart: 10 mg vial in 3.5 mL
| Dose | Volume | U-100 units | U-40 units | Doses per vial |
|---|---|---|---|---|
| 0.25 mg | 0.088 mL | 8.8 | 3.5 | 40 |
| 0.5 mg | 0.175 mL | 17.5 | 7 | 20 |
| 0.75 mg | 0.263 mL | 26.3 | 10.5 | 13 |
| 1 mg | 0.35 mL | 35 | 14 | 10 |
| 1.5 mg | 0.525 mL | 52.5 | 21 | 6 |
| 2 mg | 0.7 mL | 70 | 28 | 5 |
| 2.5 mg | 0.875 mL | 87.5 | 35 | 4 |
Doses that would need more than a full 1 mL syringe are omitted. Use less bacteriostatic water for those.
Common questions
- Does adding more water make the dose weaker?
- No. The vial still holds the same total milligrams. More water lowers the concentration, so you draw more volume for the same dose. The amount of peptide going in is identical.
- Can I use a U-40 syringe instead of U-100?
- Yes, but the numbers change. A U-40 syringe reads 40 units per mL instead of 100, so the same dose is a smaller unit number on the barrel. Both columns are in the chart above. Read the one that matches your syringe.
- What concentration is 10 mg in 3.5 mL?
- 2.86 mg/mL. Divide the vial's milligrams by the millilitres of bacteriostatic water you added: 10 ÷ 3.5 = 2.86.
- How long is it good for after mixing?
- Refrigerate reconstituted peptide at 36–46°F (2–8°C). Most references give 28–60 days once mixed, depending on the preservative in the bacteriostatic water. Do not freeze it, and inspect for cloudiness or particles before every draw.
Run your own numbers
These figures assume the vial and water volumes named above. Change either one and the units change with it.